language
中国
韩国
韩国
韩国
韩国
韩国
11 11
12 12
13 13
14 14
15 15
16 16
17 17
这是描述信息

News

What are the reasons that affect the emission of Cheapest Filter Cylinders?

  • Categories:NEWS
  • Author:
  • Origin:
  • Time of issue:2021-07-29 16:44
  • Views:

(Summary description)The reduction in dust load may be caused by the reduction in production rate, or the inspection and adjustment of the control system of the Cheapest Filter Cylinders. The solution: you can use light load to slowly start the load or use the method of pre-coating dust to solve the problem.

What are the reasons that affect the emission of Cheapest Filter Cylinders?

(Summary description)The reduction in dust load may be caused by the reduction in production rate, or the inspection and adjustment of the control system of the Cheapest Filter Cylinders. The solution: you can use light load to slowly start the load or use the method of pre-coating dust to solve the problem.

  • Categories:NEWS
  • Author:
  • Origin:
  • Time of issue:2021-07-29 16:44
  • Views:
Information

The reduction in dust load may be caused by the reduction in production rate, or the inspection and adjustment of the control system of the Cheapest Filter Cylinders. The solution: you can use light load to slowly start the load or use the method of pre-coating dust to solve the problem. . Studies have shown that too high a filtration rate will increase the discharge rate of dust. Too high a filtration rate will break the dust layer at the beginning, and the dust will impact the filter bag and cause excessive wear. If the dust filter is cleaned at this time Too high number of bags can easily cause the fabric of the filter bag to be loose, and these factors will cause the discharge of the dust collector to exceed the standard.


When setting the pulse cleaning time of the Cheapest Filter Cylinders dust collector, to ensure that the Cheapest Filter Cylinders dust collector works under undisturbed pressure, the longest pulse cleaning cycle time is set, and the pulse cleaning time can ensure the initial dust It is better not to fall off easily. The shorter the cleaning time is, the better. If the initial dust layer is insufficient, the number of cleanings can be prolonged. If the pressure difference control is used, it can improve the stability of the inlet and outlet pressure settings of the dust collector.
If the excessive discharge of the Cheapest Filter Cylinders dust collector only occurs after the filter bag is cleaned, it is necessary to check whether the cleaning compressed air pressure is too high. In the process of using Cheapest Filter Cylinders, if the discharge exceeds the standard and the operating pressure of the filter is too low than the design, it is most likely that the initial powder layer on the surface of the dust filter bag is insufficient, and the reason may be the filtration speed of the filter bag. Too high, the cleaning cycle of the filter bag is too short, the pressure of the compressed air is too high, and the dust loadability is reduced.
The above is an introduction to the reasons that affect the emission of Cheapest Filter Cylinders.

Keyword:

Copyright·Anping Senming Wire Mesh Co., Ltd 冀ICP备11013701号-1 www.300.cn